Electromagnetic train
What we will make
Click here to play the above video
Safety instructions
- This project uses magnets that are really strong. If you get the urge to put them in your mouth, this is not the experiment for you. Should you bring two magnets close by with a finger between them, some squishing is likely. The word to utter in such cases is a loud “OW!”.
- When the train is inside the coil, it will get hot - whether it moves or not. So resist the urge to leave the train inside the coil and go out to play. Or not (at your own risk).
Parts
High-grade (N35 or higher) neodymium magnets
Bare metal copper wire. 20 metres is plenty, but you can go more or less.
Any old rod of diameter greater than the AA/AAA batteries, to wind up the coil. Available at your nearby hardware store.
AA and AAA Batteries (Get both and experiment)
Steps
Step 1: Make the coil
Use the rod to create the coil. It is harder than it appears but with patience you will be able to create a coil that works. Spacing matters - do not make the turns too close to each other, or too wide apart. Just right is what you’re looking for. Make a smaller 6 inch coil first, test the train out and then make the bigger coil.
Step 2: Place the magnets
Bring two magnets together such that they try to repel each other. Then snap the AA battery in between them. This is important - either both north poles, or both south poles of the magnets should be facing outwards. You must ensure that the magnets are touching the coil, otherwise the train will not move.
Step 3: Run the train
Now place the battery with the magnets on either end gently inside the test coil. You should see it move! Now try it in the bigger coil and see if it goes smoothly all around it. When you try to put the train inside the coil and it feels like as it wants to come out of it, then reverse the ends of the of battery and try again. Now it will run!
How it works
While the math for the operation of this train is pretty complex, here is a simple “intuitive” explanation of the electromagnetic train. When the magnets touch the coil the circuit is complete and electricity starts flowing - it is effectively a short circuit. Now, as Hans Christian Orsted and Faraday later on had theorised, current through a wire causes a magnetic field, and sure enough one is created inside our coil as well.
When the magnetic poles of the coil and the neodymium magnet align up in the correct manner, the train moves.[/caption] The magnetic poles of the magnetic field created inside the coil due to the current are aligned such that one of the permanent magnets attached to the battery is “pulled in” and the the other is “pushed outwards”. The end result is that the battery begins to move inside the coil.
Troubleshooting
If the train does not work, it’s quite likely it is due to the coil not being evenly wound. Re-wind and try again. Other things to check are:
- Is the battery fully charged up? Use a multimeter to test it and ensure it reads out 1.5volts, or something close to it.
- Are the magnets aligned correctly? Flip them around and try again.
Extend the experiment
- How can we make the train go faster?
- How can we modify the train (or the track) so that it stops to pick up passengers?
- If we make the coil vertical, could the train become a rocket? If not, why not?
Hmm…interesting
Hans Christian Orsted was a close friend of the other Hans Christian - Hans Christian Andersen, that great teller of fairy tales.